Kia K900: Windshield defrosting and defogging
WARNING
Windshield heating
Do not use the 
or
position during cooling operation in
extremely humid weather. The difference between the temperature of the outside air
and that of the windshield could cause the outer surface of the windshield to fog
up, causing loss of visibility. In this case, set the mode selection knob or button
to the 
position and fan speed control
knob or button to the lower speed.
- For maximum defrosting, set the temperature control to the extreme right/hot position and the fan speed control to the highest speed.
- If warm air to the floor is desired while defrosting or defogging, set the mode to the floor-defrost position.
- Before driving, clear all snow and ice from the windshield, rear window, outside rear view mirrors, and all side windows.
- Clear all snow and ice from the hood and air inlet in the cowl grill to improve heater and defroster efficiency and to reduce the probability of fogging up the inside of the windshield.
Air Conditioning refrigerant label
The actual Air Conditioning refrigerant label in the vehicle may differ from
the illustration.
Each symbols and specification on air conditioning refrigerant label means as
below ;
1. Classifi ...
To defog inside windshield
1.Set the fan speed to the desired position.
2.Select desired temperature.
3.Press the defrost button ( ).
4.The air conditioning will be turned on according to the detected ambient temperature
...
See also:
Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band
across the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left
on the tire. Replace the tire when ...
TPMS (Tire Pressure
Monitoring System)
malfunction indicator
The TPMS malfunction indicator will
illuminate after it blinks for approximately
one minute when there is a
problem with the Tire Pressure
Monitoring System.
Have the system checked by an
auth ...
Malfunction indicator
The AVSM OFF indicator will illuminate when the Engine Start/Stop Button is turned
ON, but should go off after approximately 3 seconds.
If the indicator does not come on, or continuously remains ...
Categories
