Kia K900: To cancel cruise control, do one of the following
- Depress the brake pedal.
- Shift into N (Neutral) with an automatic transaxle.
- Move up the lever (to CANCEL) located on the steering wheel.
- Decrease the vehicle speed lower than the memory speed by 12 mph (20 km/h).
- Decrease the vehicle speed to less than approximately 20 mph (30 km/h).
- Increasing the vehicle speed to more than approximately 125 mph (200 km/h).
- The ESC is operating.
- Downshifting to the 2nd gear with manual mode.
- Operating the EPB switch. Do not operate the parking brake while driving except in an emergency situation.
Each of these actions will cancel cruise control operation (the SET indicator light in the instrument cluster will go off), but it will not turn the system off. If you wish to resume cruise control operation, move up the lever (to RES+) located on your steering wheel. You will return to your previously preset speed.
To temporarily accelerate with the cruise control on
If you want to speed up temporarily when the cruise control is on, depress the
accelerator pedal.
Increased speed will not interfere with cruise control operation or change the
set speed.
To ret ...
To resume cruising speed at more than approximately 20 mph (30 km/h)
If any method other than the CRUISE lever was used to cancel cruising speed and
the system is still activated, the most recent set speed will automatically resume
when you move the lever up (to ...
See also:
Engine compartment fuse panel (Passenger’s side)
✽ NOTICE
Not all fuse panel descriptions in this manual may be applicable to your vehicle.
It is accurate at the time of printing. When you inspect the fuse panel in your
vehicle, refer ...
Range (1)
The range is the estimated distance the vehicle can be driven with the remaining
fuel.
Distance range : 30 ~ 990 mi or 50 ~ 990 km.
If the estimated distance is below 30 mi. (50 km), the tri ...
Engine compartment fuse replacement
1.Turn the ignition switch and all other switches off.
2.Remove the fuse panel cover by pressing the tab and pulling up.
3.Check the removed fuse; replace it if it is blown. To remove or insert th ...
Categories
