Kia K900: Front seat adjustment - power
The front seat can be adjusted by using the control switches located on the doors. Before driving, adjust the seat to the proper position so as to easily control the steering wheel, pedals and switches on the instrument panel.
WARNING
The power seat is operable with the ignition OFF. Therefore, children should never be left unattended in the vehicle.
CAUTION
- The power seat is driven by an electric motor. Stop operating once the adjustment is completed, excessive operation may damage the electrical equipment.
- When in operation, the power seat consumes a large amount of electrical power. To prevent unnecessary charging system drain, don’t adjust the power seat longer than necessary while the engine is not running.
- Do not operate two or more power seat control switches at the same time. Doing so may result in power seat motor or electrical component malfunction.
- Forward and backward
- Seatback angle
- Seat cushion height
- Lumbar support (for driver’s seat)
- Cushion length adjustment (for driver’s seat)
Rear seat
(10) Seat sliding forward or backward adjustment with seatback angle adjustment
(11) Easy access button
(12) Front passenger’s seat forward and rearward
(13) Front passenger’s seat back angle
...
Forward and backward
Push the control switch forward or backward to move the seat to the desired position.
Release the switch once the seat reaches the desired position. ...
See also:
Changing the engine oil and filter
Have engine oil and filter changed by an authorized K900 Kia dealer according
to the Maintenance Schedule at the beginning of this section.
CALIFORNIA PROPOSITION 65 WARNING
Engine oil contains ch ...
If the engine stalls at a crossroad or crossing
If the engine stalls at a crossroad or crossing, set the shift lever in the N
(Neutral) position and then push the vehicle to a safe place. ...
To increase cruise control set speed
Follow either of these procedures:
Move the lever up (to RES+) and hold it. Your vehicle will accelerate. Release
the lever at the speed you want.
Move the lever up (to RES+) and release it ...
Categories
