The Blind Spot Detection System is not a substitute for proper and safe lane changing procedures. Always drive safely and use caution when changing lanes. The Blind Spot Detection System may not detect every object alongside the vehicle.
Front blind spot monitoring system is a supplemental system that shows blind spot in front of the vehicle through the AV monitor.
The front blind spot monitoring system will operate when you press the button and shift the shift lever into N(Neutral) or D(Drive) while driving less then 6.2mph (10km/h).
WARNING
This is a supplementary system. It is the responsibility of the driver to always check the area around the vehicle before driving because there is a dead zone that can't be seen through the camera. Always keep the camera lens clean. If the lens is covered with foreign matter, the camera may not operate normally.
✽ NOTICE
The front blind spot monitoring system may not operate normally, when you drive in the extremely high or low temperature area. (operating temperature: -4°F ~ 149°F (-20°C~65°C))
Charging System Warning Light
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position.
It remains on until the engine is started.
When there is a malfunction with ...
System warning
If you try to drive off depressing the accelerator pedal with the EPB applied,
but doesn't release automatically, a warning will sound and a message will appear.
If the driver's seat ...
Emergency braking
If there is a problem with the brake pedal while driving, emergency braking is
possible by pulling up and holding the EPB switch. Braking is possible only while
you are holding the EPB switch.
WA ...