Kia K900: Blade replacement
When the wipers no longer clean adequately, the blades may be worn or cracked, and require replacement.
CAUTION
To prevent damage to the wiper arms or other components, do not attempt to move the wipers manually.
CAUTION
The use of a non-specified wiper blade could result in wiper malfunction and failure.
Front windshield wiper blade
For your convenience, move the windshield wiper blades to the service position as follows;
Turn off the engine.
Move the wiper switch to the single wiping (MIST) position within 20 seconds and hold the switch until the wiper blade is in the fully up position.
1.Raise the wiper arm.
CAUTION
Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.
2.Turn the wiper blade clip. Then lift up the blade clip.
3.Push the clip (1) and push up the wiper arm (2).
4.Push down the wiper arm (3) and install the new blade assembly in the reverse order of removal.
5.Return the wiper arm on the windshield.
Blade inspection
✽ NOTICE
Commercial hot waxes applied by automatic car washes have been known to make
the windshield difficult to clean.
Contamination of either the windshield or the wiper blades with fo ...
Battery
...
See also:
Automatic turn off function
The interior lights automatically turn off approximately 20 minutes after the
engine is turned off.
If your vehicle is equipped with the theft alarm system, the interior lights
automatically turn ...
Air bag warning light
The purpose of the air bag warning light in your instrument panel is to alert
you of a potential problem with your air bag - Supplemental Restraint System (SRS).
When the ignition switch is turne ...
RCTA (Rear cross traffic alert)
When your vehicle moves backwards from a parking position, the sensor detects
approaching vehicles to the left or right side direction and gives information to
the driver.
Operating conditions
...