WARNING
Removing radiator cap
WARNING
The electric motor (cooling fan) is controlled by engine coolant temperature, refrigerant pressure and vehicle speed. It may sometimes operate even when the engine is not running. Use extreme caution when working near the blades of the cooling fan so that you are not injured by a rotating fan blades. As the engine coolant temperature decreases, the electric motor will automatically shut off. This is a normal condition. If your vehicle is equipped with GDI, the electric motor (cooling fan) may operate until you disconnect the negative battery cable.
Check the condition and connections of all cooling system hoses and heater hoses. Replace any swollen or deteriorated hoses.
The coolant level should be filled between F and L marks on the side of the coolant reservoir when the engine is cool.
If the coolant level is low, add enough distilled (deionized) water. Bring the level to F, but do not overfill. If frequent additions are required, see an authorized K900 Kia dealer for a cooling system inspection.
Recommended engine coolant
For mixture percentage, refer to the following table.
✽ NOTICE
If in doubt about mix ratio 50% water and 50% antifreeze mix is the easiest to mix together as it will be same quantity of each. It can work reasonable for most temperature range of -31°F and higher.
WARNING
Radiator cap
Do not remove the radiator cap when the engine and radiator are hot. Scalding hot coolant and steam may blow out under pressure causing serious injury.
Pre-Safe Seat belt (PSB)
The pre-safe seat belt will activate and pull the seat belt into tighter contact
against the occupant's body if a collision is detected or during certain driving
maneuvers.
CAUTION
The pre ...
Light bulbs
WARNING
Working on the lights
Prior to working on the light, firmly apply the parking brake, ensure that
the ignition switch is turned to the LOCK position and turn off the lights to avoid
sudde ...
Tire chains
Tire chains, if necessary, should be installed on the drive wheels (rear wheels).
Be sure that the chains are installed in accordance with the manufacturer's instructions.
To minimize tire and c ...