Kia K900: Warning type
The system will activate when:
1.The system is on
2.Vehicle speed is above about 18.6 mph (30 km/h)
3.Other vehicles are detected in the rear side
If a vehicle is detected within the boundary of the system, a warning light will illuminate on the outside rearview mirror and the head up display.
If the detected vehicle is not in warning range, the warning will turn off according to driving conditions.
The second stage alarm will activate when:
1.The first stage alert is on
2.The turn signal is on to change a lane
When the second stage alert is activated, a warning light will blink on the outside rearview mirror, the head up display and a alarm will sound.
If you move the turn signal switch to the original position, the second stage alert will be deactivated.
Operating conditions
The indicator on the switch will illuminate when the Blind Spot Detection System
(BSD) switch is pressed with the Engine Start/Stop Button ON.
If vehicle speed exceeds about 18.6 mph (30 km/h), t ...
Detecting sensor
The sensors are located inside of the rear bumper.
Always keep the rear bumper clean for the system to work properly. ...
See also:
On curves
On curves, the ASCC may not detect a moving vehicle in your lane, and then
your vehicle could accelerate to the set speed. Also, the vehicle speed will
rapidly slow down when the vehicle ahea ...
1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution
caused by blow-by gases being emitted from the crankcase.
This system supplies fresh filtered air to the crankcase thr ...
Seat belt warning (for driver’s seat)
The driver's seat belt warning light and chime will activate to the following
table when the ignition switch is in "ON" position.
*1Warning pattern repeats 11 times with an interv ...