Kia K900: Detecting sensor - BSD (Blind Spot Detection) / LCA (Lane Change Assist) - Blind spot detection system (BSD) - Driving your vehicle - KIA K900 2014-2026 Owner's ManualKia K900: Detecting sensor

The sensors are located inside of the rear bumper.


The sensors are located inside of the rear bumper.

Always keep the rear bumper clean for the system to work properly.

Warning type
The system will activate when: 1.The system is on 2.Vehicle speed is above about 18.6 mph (30 km/h) 3.Other vehicles are detected in the rear side If a vehicle is detected within the boundary of ...

Warning message
The message will appear to notify the driver if there are foreign substances on the rear bumper or it is hot near the rear bumper. The light on the switch and the system will turn off automatica ...

See also:

Instrument panel fuse panel
Inside the fuse/relay panel covers, you can find the fuse/relay label describing fuse/relay name and capacity. ✽ NOTICE Not all fuse panel descriptions in this manual may be applicable to ...

Economical operation
Your vehicle's fuel economy depends mainly on your style of driving, where you drive and when you drive. Each of these factors affects how many miles (kilometers) you can get from a gallon (l ...

Interior care
Interior general precautions Prevent chemicals such as perfume, cosmetic oil, sun cream, hand cleaner, and air freshener from contacting the interior parts because they may cause damage or discol ...

Copyright © www.k900kia.com 2014-2026