Kia K900: Operating conditions - BSD (Blind Spot Detection) / LCA (Lane Change Assist) - Blind spot detection system (BSD) - Driving your vehicle - KIA K900 2014-2026 Owner's ManualKia K900: Operating conditions

The indicator on the switch will illuminate when the Blind Spot Detection System


The indicator on the switch will illuminate when the Blind Spot Detection System (BSD) switch is pressed with the Engine Start/Stop Button ON.

If vehicle speed exceeds about 18.6 mph (30 km/h), the system will activate.

If you press the switch again, the switch indicator and system will be turned off.

If the ignition switch is turned OFF and ON the system returns to the previous state.

When the system is not used turn the system off by turning off the switch. When the system is turned on the warning light will illuminate for 3 seconds on the outside rearview mirror.

BSD (Blind Spot Detection) / LCA (Lane Change Assist)
...

Warning type
The system will activate when: 1.The system is on 2.Vehicle speed is above about 18.6 mph (30 km/h) 3.Other vehicles are detected in the rear side If a vehicle is detected within the boundary of ...

See also:

Drive mode integrated control system
Drive mode / Snow mode The drive mode may be selected according to the driver’s preference or road condition. The system initializes to the normal mode after the engine start/stop button has ...

Aux, USB and iPod® port
If your vehicle has an aux and/or USB(universal serial bus) port or iPod® port, you can use an aux port to connect audio devices and a USB port to plug in a USB, and an iPod® port to plug in a ...

Emergency starting
Connect cables in numerical order and disconnect in reverse order. ✽ NOTICE Your vehicle has a battery in the trunk compartment, but when you jump start your vehicle, use the jumper termi ...

Copyright © www.k900kia.com 2014-2026