The Engine Start/Stop Button must be ON position for the turn signals to function. To turn on the turn signals, move the lever up or down (A). The green arrow indicators on the instrument panel indicate which turn signal is operating.
They will self-cancel after a turn is completed. If the indicator continues to flash after a turn, manually return the lever to the OFF position.
To signal a lane change, move the turn signal lever slightly and hold it in position (B). The lever will return to the OFF position when released.
If an indicator stays on and does not flash or if it flashes abnormally, one of the turn signal bulbs may be burned out and will require replacement.
One-touch lane change function
To activate an one-touch lane change function, move the turn signal lever slightly and then release it. The lane change signals will blink 3, 5 or 7 times.
✽ NOTICE
If an indicator flash is abnormally quick or slow, a bulb may be burned out or have a poor electrical connection in the circuit.
Side curtain
To use the side curtain:
1.Lift the curtain by the hook (1).
2.Hang the curtain on both sides of the hook.
3.Pull the curtain backward by the hook (2).
4.Hang the curtain on the hook. ...
Remote keyless entry system operations
Lock (1)
All doors are locked if the lock button is pressed. If all doors (and trunk)
are closed, the hazard warning lights will blink once to indicate that all doors
(and trunk) are locked.
A ...
To convert to cruise control mode
The driver may choose to only use the cruise control mode (speed control function)
by doing as follows:
1.Turn the ASCC on (the cruise indicator light will be on but the system will
not be acti ...