Kia K900: Power windows
The ignition switch must be in the ON position for power windows to operate. Each door has a power window switch that controls the door’s window.
The driver has a power window lock switch which can block the operation of rear passenger windows.
The power windows can be operated for approximately 30 seconds after the ignition key is removed or turned to the ACC or LOCK position.
However, if the front doors are opened, the power windows cannot be operated even within the 30 second period.
✽ NOTICE
While driving with the rear windows down or with the sunroof in an open (or partially open) position, your vehicle may demonstrate a wind buffeting or pulsation noise. This noise is a normal occurrence and can be reduced or eliminated by taking the following actions. If the noise occurs with one or both of the rear windows down, partially lower both front windows approximately one inch. If you experience the noise with the sunroof open, slightly reduce the size of the sunroof opening.
Windows
(1) Driver’s door power window switch
(2) Front passenger’s door power window switch
(3) Rear door (left) power window switch
(4) Rear door (right) power window switch
(5) Window opening and clo ...
Window opening and closing
Pressing or pulling up the power window switch momentarily to the second detent
position (6) completely lowers or lifts the window even when the switch is released.
To stop the window at the desi ...
See also:
Warning type
The system will activate when:
1.The system is on
2.Vehicle speed is above about 18.6 mph (30 km/h)
3.Other vehicles are detected in the rear side
If a vehicle is detected within the boundary of ...
Storing positions into memory using the buttons on the door
Storing driver’s seat positions
1.Check that the shift lever is in P (Park) and the Engine Start/Stop Button
is in the ON position.
2.Adjust the driver seat, outside rearview mirror, HUD* (Head-up ...
Engine compartment fuse replacement
1.Turn the ignition switch and all other switches off.
2.Remove the fuse panel cover by pressing the tab and pulling up.
3.Check the removed fuse; replace it if it is blown. To remove or insert th ...