Kia K900: Using a child restraint system
For small children and babies, the use of a child seat or infant seat is required. This child seat or infant seat should be of appropriate size for the child and should be installed in accordance with the manufacturer's instructions.
For safety reasons, we recommend that the child restraint system be used in the rear seats.
Since all passenger seat belts move freely under normal conditions and only lock under extreme or emergency conditions (emergency lock mode), you must manually change these seat belts to the auto lock mode to secure a child restraint.
If the seat belt does not operate as described in this chapter, have the system checked immediately by your authorized K900 Kia dealer.
WARNING
Child seat installation
- Always follow the instructions provided by the child restraint system manufacturer. Child restraint system manufacturers know their products best.
- Failure to observe this manual's instructions regarding child restraint system and the instructions provided with the child restraint system could result in the improper installation of the child restraint system which may reduce the protection to your child in a crash or a sudden stop.
- Placing a passenger seat belt into the auto lock mode
- Securing a child restraint seat with tether anchorage system
- Securing a child restraint seat with child seat lower anchor system
Child restraint system
Children riding in the car should sit in the rear seat and must always be properly
restrained to minimize the risk of injury in an accident, sudden stop or sudden
maneuver. According to accident s ...
Placing a passenger seat belt into the auto lock mode
The auto lock mode will help prevent the normal movement of the child in the
vehicle from causing the seat belt to loosen and compromise the child restraint
system. To secure a child restraint s ...
See also:
Engine compartment
3.8L Engine
1. Engine oil dipstick
2. Engine oil filler cap
3. Engine coolant reservoir
4. Radiator cap
5. Brake fluid reservoir
6. Power steering fluid reservoir
7. Windshield washer flu ...
Electronic Stability Control (ESC) Indicator Light
This indicator light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position.
It illuminates for approximately 3 seconds and then goes off.
When there i ...
Rear curtain
To raise the rear curtain, depress the button. To lower the rear curtain, depress
the button again.
The rear curtain will be lowered automatically when you shift the shift lever
into R (Reverse ...