Kia K900: Pre-Safe Seat belt (PSB)
The pre-safe seat belt will activate and pull the seat belt into tighter contact against the occupant's body if a collision is detected or during certain driving maneuvers.
CAUTION
The pre-safe seat belt activates only when the passenger is wearing his/her seat belt.
The pre-safe seat belt warning light will illuminate if there is a problem with your pre-safe seat belt.
Have the system checked if:
- The light does not turn on briefly when you turn the engine start/stop button to the ON position.
- The light stays on after illumination for approximately 3 seconds.
- The light comes on while the vehicle is in motion.
The pre-safe seat belt system operates as below
- The seat belt is tightened when: The vehicle senses a collision Emergency braking situation occurs Loss of vehicle control
- The seat belt vibrates when: The vehicle detects and object too close to the vehicle
Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat
belts (retractor pretensioner and EFD (Emergency Fastening Device).
The pre-tensioner seat belts may be act ...
Seat belt precautions
Infant or small child
All 50 states have child restraint laws. You should be aware of the specific
requirements in your state.
Child and/or infant seats must be properly placed and installed in th ...
See also:
Electric Parking Brake (EPB) Warning Light
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position.
It illuminates for approximately 3 seconds and then goes off.
When there is ...
Forward, backward and seatback angle (for power seat)
Push the control switch forward or backward to move the seat to the desired position.
Release the switch once the seat reaches the desired position. ...
Refrigerant label
The refrigerant label is located on the underside of the hood.
The label contains the following information:
Type of refrigerant
Amount of refrigerant
...