Kia K900: Operating conditions
The indicator on the switch will illuminate when the Blind Spot Detection System (BSD) switch is pressed with the Engine Start/Stop Button ON.
If vehicle speed exceeds about 18.6 mph (30 km/h), the system will activate.
If you press the switch again, the switch indicator and system will be turned off.
If the ignition switch is turned OFF and ON the system returns to the previous state.
When the system is not used turn the system off by turning off the switch. When the system is turned on the warning light will illuminate for 3 seconds on the outside rearview mirror.
Warning type
The system will activate when:
1.The system is on
2.Vehicle speed is above about 18.6 mph (30 km/h)
3.Other vehicles are detected in the rear side
If a vehicle is detected within the boundary of ...
See also:
In the event of brake failure
If service brakes fail to operate while the vehicle is in motion, you can make
an emergency stop with the parking brake. The stopping distance, however, will be
much greater than normal.
WARNING
...
Fan speed control
The fan speed can be set to the desired speed by pressing the fan speed control
button(for front) or turning the fan speed control knob (for rear).
To change the fan speed, press the (
) part of ...
Tire rotation
To equalize tread wear, it is recommended that the tires be rotated every 7,500
miles (12,000 km) or sooner if irregular wear develops. During rotation, check the
tires for correct balance.
When ...
Categories
