Kia K900: System warning - Brake system - Driving your vehicle - KIA K900 2014-2026 Owner's ManualKia K900: System warning


If the above situation occurs, depress the brake pedal and release EPB by pressing the EPB switch.

WARNING

CAUTION

System warning

When the conversion from Auto Hold to EPB is not working properly a warning will


When the conversion from Auto Hold to EPB is not working properly a warning will sound and a message will appear.

CAUTION

Depress the brake pedal when the above message appears for the Auto Hold and EPB may not activate.

System warning

If the EPB is applied while Auto Hold is activated because of ESC (Electronic


If the EPB is applied while Auto Hold is activated because of ESC (Electronic Stability Control) signal, a warning will sound and a message will appear .

EPB malfunction indicator

This warning light illuminates if the engine start/stop button is changed to


This warning light illuminates if the engine start/stop button is changed to the ON position and goes off in approximately 3 seconds if the system is operation normally.

If the EPB malfunction indicator remains on, comes on while driving, or does not come on when the engine start/stop button is changed to the ON position, this indicates that the EPB may have malfunctioned.

If this occurs, have your vehicle checked by an authorized K900 Kia dealer as soon as possible.

The EPB malfunction indicator may illuminate when the ESC indicator comes on to indicate that the ESC is not working properly, but it does not indicate a malfunction of the EPB.

CAUTION

Electric parking brake (EPB)
Applying the parking brake To apply the EPB (electric parking brake): 1.Depress the brake pedal. 2.Pull up the EPB switch. Make sure the warning light comes on. Also, the EPB is applied automat ...

Emergency braking
If there is a problem with the brake pedal while driving, emergency braking is possible by pulling up and holding the EPB switch. Braking is possible only while you are holding the EPB switch. WA ...

See also:

High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back for low beams. The high beam indicator will illuminate when the headlight high beams are switched on. To prevent ...

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perfo ...

Tire sidewall labeling
This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be use ...

Copyright www.k900kia.com 2014-2026