Kia K900: Front blind spot monitoring system - Features of your vehicle - KIA K900 2014-2026 Owner's ManualKia K900: Front blind spot monitoring system

The Blind Spot Detection System is not a substitute for proper and safe lane


The Blind Spot Detection System is not a substitute for proper and safe lane changing procedures. Always drive safely and use caution when changing lanes. The Blind Spot Detection System may not detect every object alongside the vehicle.

Front blind spot monitoring system is a supplemental system that shows blind spot in front of the vehicle through the AV monitor.

The front blind spot monitoring system will operate when you press the button and shift the shift lever into N(Neutral) or D(Drive) while driving less then 6.2mph (10km/h).

WARNING

This is a supplementary system. It is the responsibility of the driver to always check the area around the vehicle before driving because there is a dead zone that can't be seen through the camera. Always keep the camera lens clean. If the lens is covered with foreign matter, the camera may not operate normally.

✽ NOTICE

The front blind spot monitoring system may not operate normally, when you drive in the extremely high or low temperature area. (operating temperature: -4°F ~ 149°F (-20°C~65°C))

Changing rear view angle
1. Top view When Top View is selected, the rear view angle is displayed as if looking down from above. 2. Normal view When Normal View is selected, the rear view angle is displayed in a custo ...

Surround view monitoring system (SVM)
The Surround View Monitoring System (SVM) is not a substitute for proper and safe parking procedures. The Surround View Monitoring System (SVM) may not detect every object surrounding the vehic ...

See also:

Brake operation
If the driver releases the accelerator after the warning, the AVSM automatically brakes the vehicle gently. If the driver hits the brake to reduce vehicle speed, the brake assistant system ...

Fuel Economy
...

Instrument panel fuse replacement
1.Turn the ignition switch and all other switches off. 2.Lift the end of strip (1) up. 3.Press the fastener head with screw driver and then pull the fastener out. 4.Lift the rear portion of sma ...

Copyright © www.k900kia.com 2014-2026