In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty.
The spray and wiper operation will continue until you release the lever. If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.
The reservoir filler neck is located in the front of the engine compartment on the passenger side.
CAUTION
To prevent possible damage to the washer pump, do not operate the washer when the fluid reservoir is empty.
WARNING
Do not use the washer in freezing temperatures without first warming the windshield with the defrosters; the washer solution could freeze on contact with the windshield and obscure your vision.
CAUTION
Snow mode
Snow mode helps the driver to drive more effectively on slippery roads such as
snowy or muddy roads.
If the SNOW MODE button is pressed, the SNOW mode will operate regardless of
whichev ...
Emergency Trunk Safety Release
Your vehicle is equipped with an Emergency Trunk Safety Release lever located
inside the trunk. When someone is inadvertently locked in the trunk, the trunk can
be opened by moving the lever in ...
The LDWS does not operate when
The driver turns on the turn signal or the hazard warning flasher to change
lane.
Driving on the lane line.
✽ NOTICE
To change lane, operate the turn signal switch then change the l ...