Kia K900: Detecting sensor - BSD (Blind Spot Detection) / LCA (Lane Change Assist) - Blind spot detection system (BSD) - Driving your vehicle - KIA K900 2014-2026 Owner's ManualKia K900: Detecting sensor

The sensors are located inside of the rear bumper.


The sensors are located inside of the rear bumper.

Always keep the rear bumper clean for the system to work properly.

Warning type
The system will activate when: 1.The system is on 2.Vehicle speed is above about 18.6 mph (30 km/h) 3.Other vehicles are detected in the rear side If a vehicle is detected within the boundary of ...

Warning message
The message will appear to notify the driver if there are foreign substances on the rear bumper or it is hot near the rear bumper. The light on the switch and the system will turn off automatica ...

See also:

Exterior care
Exterior general caution It is very important to follow the label directions when using any chemical cleaner or polish. Read all warning and caution statements that appear on the label. Finish mai ...

Armrest
To use the armrest, pull it forward from the seatback. ...

Air bag Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. It illuminates for approximately 6 seconds and then goes off. When there is ...

Copyright © www.k900kia.com 2014-2026