Kia K900: Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty.
The spray and wiper operation will continue until you release the lever. If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.
The reservoir filler neck is located in the front of the engine compartment on the passenger side.
CAUTION
To prevent possible damage to the washer pump, do not operate the washer when the fluid reservoir is empty.
WARNING
Do not use the washer in freezing temperatures without first warming the windshield with the defrosters; the washer solution could freeze on contact with the windshield and obscure your vision.
CAUTION
- To prevent possible damage to the wipers or windshield, do not operate the wipers when the windshield is dry.
- To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner, or other solvents on or near them.
- To prevent damage to the wiper arms and other components, do not attempt to move the wipers manually.
Auto control
The rain sensor located on the upper end of the windshield glass senses the amount
of rainfall and controls the wiping cycle for the proper interval.
The more it rains, the faster the wiper opera ...
Interior light
CAUTION
Do not use the interior lights for extended periods when the engine is not
running. It may cause battery discharge.
WARNING
Do not use the interior lights when driving in the dark. Accide ...
See also:
Glove box lamp
The glove box lamp comes on when the glove box is opened.
CAUTION
To prevent unnecessary charging system drain, close the glove box securely
after using the glove box. ...
Puddle lamp
When all the doors (and trunk) are locked and closed, the puddle lamp will come
on for about 15 seconds if any of the below is performed.
When the door unlock button is pressed on the smart key. ...
Starting the engine with a smart key
1.Carry the smart key or leave it inside the vehicle.
2.Make sure the parking brake is firmly applied
3.Place the transaxle shift lever in P (Park).
4.Press the ENGINE START/STOP button while depre ...
Categories
