Kia K900: Warning type
The system will activate when:
1.The system is on
2.Vehicle speed is above about 18.6 mph (30 km/h)
3.Other vehicles are detected in the rear side
If a vehicle is detected within the boundary of the system, a warning light will illuminate on the outside rearview mirror and the head up display.
If the detected vehicle is not in warning range, the warning will turn off according to driving conditions.
The second stage alarm will activate when:
1.The first stage alert is on
2.The turn signal is on to change a lane
When the second stage alert is activated, a warning light will blink on the outside rearview mirror, the head up display and a alarm will sound.
If you move the turn signal switch to the original position, the second stage alert will be deactivated.
Operating conditions
The indicator on the switch will illuminate when the Blind Spot Detection System
(BSD) switch is pressed with the Engine Start/Stop Button ON.
If vehicle speed exceeds about 18.6 mph (30 km/h), t ...
Detecting sensor
The sensors are located inside of the rear bumper.
Always keep the rear bumper clean for the system to work properly. ...
See also:
Recommended SAE viscosity number
Always be sure to clean the area around any filler plug, drain plug, or dipstick
before checking or draining any lubricant. This is especially important in dusty
or sandy areas and when the vehicl ...
Antenna
When the radio power switch is turned on while the Engine Start/Stop Button is
in either the “ON” or “ACC” position, your car will receive both AM and FM broadcast
signals through the an ...
Closing the fuel filler lid
1.To install the cap, turn it clockwise until it "clicks" once. This indicates
that the cap is securely tightened.
2.Close the fuel filler lid and push it lightly and make sure that it is ...
Categories
