The front passenger's seat belt warning light will activate to the following table when the ignition switch is in "ON" position.
*1 The seat belt warning light will go off if the vehicle speed decreases below 3 mph (5 km/h). If the vehicle speed increases above 3 mph (5 km/h), the warning light will blink again.
WARNING
Riding in an improper position adversely affects the front passenger's seat belt warning system. It is important for the driver to instruct the passenger as to the proper seating instructions as contained in this manual.
Check spark plugs and ignition system
Inspect your spark plugs as described in section 7 and replace them if necessary.
Also check all ignition wiring and components to be sure they are not cracked, worn
or damaged in any way. ...
TPMS (Tire Pressure
Monitoring System)
malfunction indicator
The TPMS malfunction indicator will
illuminate after it blinks for approximately
one minute when there is a
problem with the Tire Pressure
Monitoring System.
Have the system checked by an
auth ...
Windshield wipers
Operates as follows when the Engine Start/Stop Button is turned ON.
MIST :
For a single wiping cycle, push the lever upward and release it with the lever
in the OFF position. The wipers will op ...