Kia K900: Electronic Brake force Distribution (EBD) System Warning Light
These two warning lights illuminate at the same time while driving:
When the ABS and regular brake system may not work normally. In this case, have your vehicle inspected by an authorized K900 Kia dealer.
WARNING
Electronic Brake force Distribution (EBD) System Warning Light
When both ABS and Parking Brake & Brake Fluid Warning Lights are on, the brake system will not work normally and you may experience an unexpected and dangerous situation during sudden braking. In this case, avoid high speed driving and abrupt braking. Have your vehicle inspected by an authorized K900 Kia dealer as soon as possible.
✽ NOTICE - Electronic Brake force Distribution (EBD) System Warning Light
When the ABS Warning Light is on or both ABS and Parking Brake & Brake Fluid Warning Lights are on, the speedometer, odometer, or tripmeter may not work. Also, the EPS Warning Light may illuminate and the steering effort may increase or decrease. In this case, have your vehicle inspected by an authorized K900 Kia dealer as soon as possible.
Anti-lock Brake System (ABS) Warning Light
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position.
It illuminates for approximately 3 seconds and then goes off.
When there is ...
Malfunction Indicator Lamp (MIL)
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position.
It remains on until the engine is started.
When there is a malfunction with ...
See also:
Automatic climate control system
1. Driver’s temperature control button
2. AUTO (automatic control) button
3. OFF button
4. Fan speed control button
5. Air conditioning button
6. Mode selection button
7. Front windshield de ...
Range (1)
The range is the estimated distance the vehicle can be driven with the remaining
fuel.
Distance range : 30 ~ 990 mi or 50 ~ 990 km.
If the estimated distance is below 30 mi. (50 km), the tri ...
Instrument panel fuse replacement
1.Turn the ignition switch and all other switches off.
2.Lift the end of strip (1) up.
3.Press the fastener head with screw driver and then pull the fastener out.
4.Lift the rear portion of sma ...