Kia K900: Electric parking brake (EPB)

Applying the parking brake

To apply the EPB (electric parking brake):

1.Depress the brake pedal.

2.Pull up the EPB switch.

Make sure the warning light comes on.

Also, the EPB is applied automatically if the Auto Hold button is on when the Engine Start/Stop Button is OFF position. (for shift by cable)

Also, the EPB is applied automatically when the Engine Start/Stop Button is OFF position.(for shift by wire)

However, if you press the EPB switch after the engine is turned off, the EPB will not be applied.

CAUTION

Do not operate the parking brake / EPB while the vehicle is moving except in an emergency situation.

Releasing the parking brake

To release the EPB (electric parking brake), press the EPB switch in the following condition:

• Set the Engine Start/Stop Button in the ON position.
• Depress the brake pedal.

Make sure the brake warning light goes off.

To release EPB (electric parking brake) automatically:

• Shift lever in P (Park) With the engine running depress the brake pedal and shift out of P (Park) to R (Rear), N (Neutral) or D (Drive).
• Shift lever in N (Neutral) With the engine running depress the brake pedal and shift out of N (Neutral) to R (Rear) or D (Drive).
• Automatic transaxle vehicle

1. Start the engine.

2. Fasten the driver's seat belt.

3. Close the driver's door, engine hood and trunk.

4. Depress the accelerator pedal while the shift lever is in R (Rear), D (Drive) or M (Manual) mode.

Make sure the brake warning light goes off.

✽ NOTICE

• For your safety, you can engage the EPB even though the Engine Start/Stop Button is in the OFF position, but you cannot release it.
• For your safety, depress the brake pedal and release the parking brake manually with the EPB switch when you drive downhill or when backing up the vehicle.

CAUTION

• If the parking brake warning light is still on even though the EPB has been released, have the system checked by an authorized K900 Kia dealer.
• Do not drive your vehicle with the EPB applied. It may cause excessive brake pad and brake rotor wear.

EPB (electric parking brake) may be automatically applied when:

• The EPB is overheated
• Requested by other systems