Kia K900: 135,000 miles (216,000 km) or 108 months
- Rotate tires
- Inspect air cleaner filter
- Inspect vacuum hose
- Inspect air conditioning refrigerant
- Inspect brake hoses and lines
- Inspect drive shafts and boots
- Inspect exhaust pipe and muffler
- Inspect front brake disc/pads, calipers
- Inspect fuel lines, fuel hoses and connections
- Inspect vapor hose and fuel filler cap
- Inspect fuel tank air filter
- Inspect propeller shaft
- Inspect rear brake disc/pads
- Inspect steering gear box, linkage & boots/lower arm ball joint, upper arm ball joint
- Inspect suspension mounting bolts
- Inspect drive belts (First, 60,000 miles (96,000 km) or 72 months after every 15,000 miles (24,000 km) or 24 months)*4
- Inspect power steering fluid
- Inspect EHPS (Electronic Hydraulic Power Steering) motor pump and hoses
- Replace climate control air filter (for evaporator and blower unit)
- Replace engine oil and filter (135,000 miles (216,000 km) or 216 months)
- Add fuel additives *1 (135,000 miles (216,000 km) or 216 months)
127,500 miles (204,000 km) or 102 months
Rotate tires
Inspect air cleaner filter
Inspect fuel lines, fuel hoses and connections
Inspect vapor hose and fuel filler cap
Inspect fuel tank air filter
Inspect vacuum hose
Inspect po ...
142,500 miles (228,000 km) or 114 months
Rotate tires
Inspect air cleaner filter
Inspect fuel lines, fuel hoses and connections
Inspect vapor hose and fuel filler cap
Inspect fuel tank air filter
Inspect vacuum hose
Inspect po ...
See also:
Checking the amount of air conditioner refrigerant and compressor lubricant
When the amount of refrigerant is low, the performance of the air conditioning
is reduced. Overfilling also has a negative impact on the air conditioning system.
Therefore, if abnormal operation is ...
Pre-Safe Seat belt (PSB)
The pre-safe seat belt will activate and pull the seat belt into tighter contact
against the occupant's body if a collision is detected or during certain driving
maneuvers.
CAUTION
The pre ...
Turn signals and lane change signals
The Engine Start/Stop Button must be ON position for the turn signals to function.
To turn on the turn signals, move the lever up or down (A). The green arrow indicators
on the instrument panel ...