Kia K900: Seat belt restraint system
Seat belts are designed to bear upon the bony structure of the body, and should be worn low across the pelvis, chest and shoulders as applicable. wearing the lap section of the belt across the abdominal area must be avoided.
Seat belts should be adjusted as firmly as possible, consistent with comfort, to provide the protection for which they have been designed.
A slack belt will greatly reduce the protection afforded to the wearer. Care should be taken to avoid contamination of the webbing with polishes, oils and chemicals, and particularly battery acid. Cleaning may safely be carried out using mild soap and water. The belt should be replaced if webbing becomes frayed, contaminated or damaged.
- For maximum restraint system protection, the seat belts must always be used whenever the vehicle is moving. A properly positioned shoulder belt should be positioned midway over your shoulder across your collarbone.
- Never allow children to ride in the front passenger seat. See child restraint system section for further discussion.
WARNING
Shoulder belt
Never wear the shoulder belt under your arm or behind your back. An improperly positioned shoulder belt cannot protect the occupant in a crash.
WARNING
Damaged seat belt
Replace the entire seat belt assembly if any part of the webbing or hardware is damaged as you can no longer be sure that a damaged seat belt will provide protection in a crash.
WARNING
Twisted seat belt
Make sure your seat belt is not twisted when worn. A twisted seat belt may not properly protect you in an accident and could even cut into your body.
WARNING
Seat belt buckle
Do not allow foreign material (gum, crumbs, coins, etc.) to obstruct the seat belt buckle. This may prevent the seat belt from fastening securely.
- Seat belt warning (for driver’s seat)
- Seat belt warning (for front passenger’s seat)
- Seat belt - Driver's 3-point system with emergency locking retractor
- Seat belts - Front passenger and rear seat 3-point system with combination locking retractor
Seat belts
...
Seat belt warning (for driver’s seat)
The driver's seat belt warning light and chime will activate to the following
table when the ignition switch is in "ON" position.
*1Warning pattern repeats 11 times with an interv ...
See also:
High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back
for low beams.
The high beam indicator will illuminate when the headlight high beams are switched
on.
To prevent ...
Sensor to detect distance to the vehicle ahead
The sensor detects distance to the vehicle ahead.
If the sensor is covered with dirt or other foreign matter, the vehicle to vehicle
distance control may not operate correctly.
Always keep the s ...
Auto Defogging System
Auto Defogging reduces the probability of fogging up the inside of the windshield
by automatically sensing the moisture of inside the windshield.
The Auto Defogging System operates when the heate ...