Kia K900: The LDWS may not warn you even if the vehicle leaves the lane, or may warn you
even if the vehicle does not leave the lane when
- The lane can't be visible due to snow, rain, stain, a puddle or other environmental
conditions.
- The brightness of the outside changes suddenly such as tunnel enter/exit.
- Not turning on the headlight at night or in the tunnel, or light level is
low.
- Difficult to distinguish the color of the lane from the road.
- Driving on a steep grade or a curve.
- Light such as street light, sunlight or oncoming vehicle light reflects
from water on the road.
- The lens or windshield is stained with foreign matter.
- The sensor cannot detect the lane because of fog, heavy rain or heavy snow.
- The surrounding of the inside rear view mirror temperature is high due to
a direct ray of light.
- The lane is very wide or narrow.
- The lane line is damaged or indistinct.
- The windshield is fogged by humid air in the vehicle.
- The shadow is on the lane line by a median strip.
- The sensor cannot distinguish the lane from the road due to the dust.
- There is a mark similar to a lane line.
- There is a boundary structure.
- The distance from vehicle ahead is very short or the vehicle ahead drives
hiding the lane line.
- The vehicle vibrates heavily due to road conditions.
- The lane number increases or decreases or the lane lines are crossing.
- Putting something on the dashboard.
- Driving with the sun in front of you.
- Driving in areas under construction.
- The lane line is more than two in either side (Left/Right)
The driver turns on the turn signal or the hazard warning flasher to change
lane.
Driving on the lane line.
✽ NOTICE
To change lane, operate the turn signal switch then change the l ...
The Blind Spot Detection System (BSD) uses a radar sensor to alert the driver.
It senses the rear side territory of the vehicle and provides an indication to
the driver if it detects an object ap ...
See also:
Seat belt warning (for front passenger’s seat)
The front passenger's seat belt warning light will activate to the following
table when the ignition switch is in "ON" position.
*1 The seat belt warning light will go off if the ...
Forward and backward
Push the control switch forward or backward to move the seat to the desired position.
Release the switch once the seat reaches the desired position. ...
Sliding the sunroof
When the sunshade is closed
If you pull the sunroof control lever backward to the second detent position,
the sunshade will slide all the way open, then the sunroof glass will slide all
the way ...