Kia K900: Front seat adjustment - power
The front seat can be adjusted by using the control switches located on the doors. Before driving, adjust the seat to the proper position so as to easily control the steering wheel, pedals and switches on the instrument panel.
WARNING
The power seat is operable with the ignition OFF. Therefore, children should never be left unattended in the vehicle.
CAUTION
- The power seat is driven by an electric motor. Stop operating once the adjustment is completed, excessive operation may damage the electrical equipment.
- When in operation, the power seat consumes a large amount of electrical power. To prevent unnecessary charging system drain, don’t adjust the power seat longer than necessary while the engine is not running.
- Do not operate two or more power seat control switches at the same time. Doing so may result in power seat motor or electrical component malfunction.
- Forward and backward
- Seatback angle
- Seat cushion height
- Lumbar support (for driver’s seat)
- Cushion length adjustment (for driver’s seat)
Rear seat
(10) Seat sliding forward or backward adjustment with seatback angle adjustment
(11) Easy access button
(12) Front passenger’s seat forward and rearward
(13) Front passenger’s seat back angle
...
Forward and backward
Push the control switch forward or backward to move the seat to the desired position.
Release the switch once the seat reaches the desired position. ...
See also:
Electrical equipment
The electrical system of your vehicle is designed to perform under all reasonably
expected operating conditions. However, before any additional electrical equipment
is installed in your vehicle, c ...
Jack label
The actual Jack label in the vehicle may differ from the illustration. For more
detailed specifications, refer to the label attached to the jack.
1.Model Name
2.Maximum allowable load
3.When us ...
Closing the hood
1.Before closing the hood, check the following:
All filler caps in engine compartment must be correctly installed.
Gloves, rags or any other combustible material must be removed from the
engi ...
Categories
