The Blind Spot Detection System is not a substitute for proper and safe lane changing procedures. Always drive safely and use caution when changing lanes. The Blind Spot Detection System may not detect every object alongside the vehicle.
Front blind spot monitoring system is a supplemental system that shows blind spot in front of the vehicle through the AV monitor.
The front blind spot monitoring system will operate when you press the button and shift the shift lever into N(Neutral) or D(Drive) while driving less then 6.2mph (10km/h).
WARNING
This is a supplementary system. It is the responsibility of the driver to always check the area around the vehicle before driving because there is a dead zone that can't be seen through the camera. Always keep the camera lens clean. If the lens is covered with foreign matter, the camera may not operate normally.
✽ NOTICE
The front blind spot monitoring system may not operate normally, when you drive in the extremely high or low temperature area. (operating temperature: -4°F ~ 149°F (-20°C~65°C))
Engine compartment fuse panel (Passenger’s side)
✽ NOTICE
Not all fuse panel descriptions in this manual may be applicable to your vehicle.
It is accurate at the time of printing. When you inspect the fuse panel in your
vehicle, refer ...
Instrument panel fuse replacement
1.Turn the ignition switch and all other switches off.
2.Lift the end of strip (1) up.
3.Press the fastener head with screw driver and then pull the fastener out.
4.Lift the rear portion of sma ...
Adaptive Front Lighting System (AFLS) Warning Light
This warning light blinks:
Once you set the Engine Start/Stop Button to the ON position. It illuminates
for approximately 3 seconds and then goes off.
When there is a malfunction with the A ...