Kia K900: ECO mode (Active ECO)
Active ECO helps improve fuel efficiency by controlling certain engine and transaxle
system operating parameters. Fuel efficiency depends on the driver's driving habit
and road condition.
- When the DRIVE MODE button is pressed and the ECO mode is selected, the
ECO indicator (green) will illuminate to show that the Active ECO is operating.
- When the Active ECO is activated, and the engine start/stop button is turned
off and on it will change to NORMAL mode. To turn on the ECO mode press the
DRIVE MODE button till it is selected.
When Active ECO is activated:
- The acceleration may slightly be reduced eventhough you depress the accelerator
fully.
- The air conditioner performance may be limited
- The shift pattern of the automatic transaxle may change.
- The engine noise may get louder.
The above situations are normal conditions when the active eco system is activated
to improve fuel efficiency.
Limitation of Active ECO operation:
If the following conditions occur while Active ECO is operating, the system operation
is limited even though there is no change in the ECO indicator.
- When the coolant temperature is low: The system will be limited until engine
performance becomes normal.
- When driving up a hill: The system will be limited to gain power when driving
uphill because the engine torque is restricted.
- When using manual mode: The system will be limited according to the shift
location.
- When the accelerator pedal is deeply depressed for a few seconds: The system
will be limited, judging that the driver wants to speed up.
Drive mode / Snow mode
The drive mode may be selected according to the driver’s preference or road condition.
The system initializes to the normal mode after the engine start/stop button
has b ...
SPORT mode focuses on dynamic driving by automatically controlling the steering
wheel, engine and transaxle system.
When the DRIVE MODE button is pressed and the SPORT mode is selected ...
See also:
Inside rearview mirror
Adjust the rearview mirror so that the center view through the rear window is
seen. Make this adjustment before you start driving.
Do not place objects in the rear seat which would interfere with y ...
High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back
for low beams.
The high beam indicator will illuminate when the headlight high beams are switched
on.
To prevent ...
To Reset the Power Trunk
If the battery has been discharged or disconnected, or if the related fuse has
been replaced or disconnected, reset the power trunk as follows:
1. Move the shift lever to the P(Park) position.
2. ...