Kia K900: Detecting sensor - BSD (Blind Spot Detection) / LCA (Lane Change Assist) - Blind spot detection system (BSD) - Driving your vehicle - KIA K900 2014-2024 Owner's ManualKia K900: Detecting sensor

The sensors are located inside of the rear bumper.


The sensors are located inside of the rear bumper.

Always keep the rear bumper clean for the system to work properly.

Warning type
The system will activate when: 1.The system is on 2.Vehicle speed is above about 18.6 mph (30 km/h) 3.Other vehicles are detected in the rear side If a vehicle is detected within the boundary of ...

Warning message
The message will appear to notify the driver if there are foreign substances on the rear bumper or it is hot near the rear bumper. The light on the switch and the system will turn off automatica ...

See also:

30,000 miles (48,000 km) or 24 months
Rotate tires Inspect vacuum hose Inspect air conditioning refrigerant Inspect brake hoses and lines Inspect drive shafts and boots Inspect exhaust pipe and muffler Inspect front brake d ...

Power Trunk
(1) Power Trunk Main Control button (or lever) (2) Power Trunk Open button (3) Power Trunk Close button (4) Power Trunk Lock button To open: 1. Make sure the shift lever is in P (Park). 2. T ...

ESC OFF usage
When driving It’s a good idea to keep the ESC turned on for daily driving whenever possible. To turn ESC off while driving, press the ESC OFF button while driving on a flat road surface. N ...

Copyright © www.k900kia.com 2014-2024