Applying the parking brake
To apply the EPB (electric parking brake):
1.Depress the brake pedal.
2.Pull up the EPB switch.
Make sure the warning light comes on.
Also, the EPB is applied automatically if the Auto Hold button is on when the Engine Start/Stop Button is OFF position. (for shift by cable)
Also, the EPB is applied automatically when the Engine Start/Stop Button is OFF position.(for shift by wire)
However, if you press the EPB switch after the engine is turned off, the EPB will not be applied.
CAUTION
Do not operate the parking brake / EPB while the vehicle is moving except in an emergency situation.
Releasing the parking brake
To release the EPB (electric parking brake), press the EPB switch in the following condition:
Make sure the brake warning light goes off.
To release EPB (electric parking brake) automatically:
1. Start the engine.
2. Fasten the driver's seat belt.
3. Close the driver's door, engine hood and trunk.
4. Depress the accelerator pedal while the shift lever is in R (Rear), D (Drive) or M (Manual) mode.
Make sure the brake warning light goes off.
✽ NOTICE
CAUTION
EPB (electric parking brake) may be automatically applied when:
In the event of brake failure
If service brakes fail to operate while the vehicle is in motion, you can make
an emergency stop with the parking brake. The stopping distance, however, will be
much greater than normal.
WARNING
...
Removing and storing the spare tire
Turn the tire hold-down wing bolt counterclockwise.
Store the tire in the reverse order of removal.
To prevent the spare tire and tools from “rattling” while the vehicle is in motion,
store them ...
To resume cruising speed at more than approximately 20 mph (30 km/h)
If any method other than the CRUISE lever was used to cancel cruising speed and
the system is still activated, the most recent set speed will automatically resume
when you move the lever up (to ...