Operates as follows when the Engine Start/Stop Button is turned ON.
MIST :
For a single wiping cycle, push the lever upward and release it with the lever in the OFF position. The wipers will operate continuously if the lever is pushed upward and held.
OFF :
Wiper is not in operation
AUTO :
The rain sensor located on the upper end of the windshield glass senses the amount of rainfall and controls the wiping cycle for the proper interval.
The more it rains, the faster the wiper operates. When the rain stops, the wiper stops. To vary the speed setting, turn the speed control knob (B).
LO :
Normal wiper speed
HI :
Fast wiper speed
✽ NOTICE
If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation.
Drive mode integrated control system
Drive mode / Snow mode
The drive mode may be selected according to the driver’s preference or road condition.
The system initializes to the normal mode after the engine start/stop button
has b ...
ASCC will be temporarily canceled when
Cancelled manually
The brake pedal is depressed.
Move down the lever (to CANCEL) located on the steering wheel.
The ASCC turns off temporarily when the indicator on the LCD display turns of ...
Parking Brake & Brake Fluid Warning Light
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position.It
illuminates for approximately 3 seconds It remains on if the parking brake i ...