Some vehicles ahead in your lane cannot be recognized by the sensor as follows:
- Narrow vehicles such as motorcycles or bicycles
- Vehicles offset to one side
- Slow-moving vehicles or suddendecelerating vehicles
- Stopped vehicles
- Vehicles with small rear profile such as trailers with no loads
A vehicle ahead cannot be recognized correctly by the sensor if any of following occurs:
- When the vehicle is pointing upwards due to overloading in the trunk
- While making turns by steering
- When driving to one side of the lane
- When driving on narrow lanes or on curves
Adjust your vehicle speed by depressing the brake pedal according to the road condition ahead and driving condition.
When vehicles are at a standstill and the vehicle in front of you changes to the next lane, be careful when your vehicle starts to move because it may not recognize the stopped vehicle in front of you.
Always look out for pedestrians when your vehicle is maintaining a distance with the vehicle ahead.
Always be cautious for vehicles with higher height or vehicles carrying loads that sticks out to the back of the vehicle.
WARNING
CAUTION
The ASCC may not operate temporarily due to electrical interference.
Hazard warning flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme
caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs are ...
Floor mat anchor(s)
When using a floor mat on the floor carpet, make sure it attaches to the floor
mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward.
WARNING
After market floor mat
Do no ...
To Reset the Power Trunk
If the battery has been discharged or disconnected, or if the related fuse has
been replaced or disconnected, reset the power trunk as follows:
1. Move the shift lever to the P(Park) position.
2. ...